Differences

This shows you the differences between two versions of the page.

--- software:tortugabot_ros2 [2025/04/03 09:20] – [Hokuyo Lidar] s_fuyedc
+++ software:tortugabot_ros2 [2025/05/27 10:14] (current) – [Hokuyo Lidar] s_fuyedc
@@ Line 49: / Line 49: @@
 {{:software:hokuyo_w_gateway.png?800|}}
+If the Hokuyo is reset to factory defaults, put the IPv4 Address to 192.168.0.1 instead.
 ==== DS3 Controller Bluetooth Setup ====
@@ Line 202: / Line 203: @@
 ros2 run tf2_ros static_transform_publisher --frame-id base_footprint --child-frame-id laser
 </code>
+If the Hokuyo is reset to factory defaults, change the IP in 'tortugabot_ws/urg_node2/config/params_ether.yaml' to '192.168.0.10'.
@@ Line 228: / Line 230: @@
 # Add user to dialout
 sudo adduser $USER dialout
+sudo adduser $USER roscourse
 sudo adduser roscourse dialout
@@ Line 244: / Line 247: @@
 <code>
 # user: sudo
-sudo apt install ros-dev-tools
+sudo apt install ros-dev-tools ros-jazzy-topic-tools
-# allow sudo user arthur to see roscourse directories
-sudo adduser arthur roscourse
 sudo rosdep init
 </code>
@@ Line 272: / Line 273: @@
 rosdep install -i --from-path /home/roscourse/tortugabot_ws/src --rosdistro jazzy
 </code>
+Build the workspace and source the executables.
 <code>
 # user: roscourse
-# Build the workspace
+cd ~/tortugabot_ws
-cd ..
 colcon build
 source install/setup.bash
@@ Line 293: / Line 295: @@
 # laser
 ros2 launch urg_node2 urg_node2.launch.py
+# Throttle laser frequency to 10 hz
+ros2 run topic_tools throttle messages /scan 10.0
 # transform base_footprint < laser